CP-TC-1 was designed for control panel installation and due to its very small size it allows an optimal use of the available space. 8A switching power, multi-voltage input, display showing nominal and actual value, 2 point/PID-control, signal relay and analog outputs are only some of the advantages of this device. Moreover, a time-saving transmission of parameters is possible via an interface and an optionally available memory module.

Technical data

Adjustment options:

From -200 ….1760°C (depending on the sensor)

Display:

4 digit set point display (red), 4 digit actual value display (green)
6 signal LED for heating „on“, alarm 1, alarm 2, manual „on“, autotuning, interface communication

Operating voltage:

24...230V AC/DC +10/-15%, 3,5VA

Supply frequency:

50/60Hz

Sensor input:

Thermocouples: K, J, R, S (incl. automatic cold junction temperature compensation)
Resistance thermometer: PT 100, PT500, PT1000, Ni100, PTC1k, NTC10k, 6kohm, 150kohm
Standard signal: 0..10V, 0..40mV, 0..20mA, 4..20mA
Measuring tolerance: +/-0,2%, +/-1digit

Analog output:

SSR output 12V/30mA

Switching power:

Relay 1 (250V/8A), relay 2 (250V/5A)

Type of control:

P, PI, PD, PID, 2 point with hysteresis, optionally with autotuning of the parameter, also adjustable as limiter

Ramp function:

adjustable

Protection class:

II

Degree of protection:

IP65 (front), IP20 (clamps)

Oprating temperature:

0...+45°C

Storage temperature:

-30...+70°C

Housing material:

polycarbonate

Dimensions:

[77x35x53]mm

Hole size:

[70,5x28,5]mm

Weight:

100g

Additional features:

• time-saving copying of the parameters of one control onto other controls by means of a plug-in card
• Optionally Modbus (RS485) instead of the SSR output